top of page
  • Similar to other Ball Joint Holders but instead bypasses the screw-in ball joint sleeve and uses the ball joint housing as the center point.
  • This allows another .250” or more of clearance inside the upper control arm, where everything is getting so tight these days.
  • Allows more shock clearance.
  • Our ball joint ring is machined to allow your existing ball joint pin to be used which in turn eliminates the ball joint housing completely!
  • Our extra clearance holders come with set-screws installed
  • Aluminum cap, Steel Cap, O-rings and Grease zerks are sold separately
  • RH holder is angled – LH holder is straight
  • Ball Joint holders are sold as each

Low Profile Ball Joint Holder Screw In

SKU: 100-07-101X
    bottom of page